Welcome, Guest
Username: Password: Remember me

Search Micromat Forum

Keyword

TOPIC: Program terminates unexpectedlyhttps://www.micromat.com/components/com_kunena/template/micromat/imag

Program terminates unexpectedlyhttps://www.microm​at.com/components/com_kunena/t​emplate/micromat/imag 27 May 2014 11:16 #5493

Hi,
I just today bought a version of the above mentioned software for my Macbook pro 13” late 20143 model with 16GB Ram and 512 GB SSD. The system currently runs OSX 10.2.9.
After installing the program it starts techtoolpro 7 that asks for an update to version 7.0.4. Shortly after starting the update (and also without starting the update) the program freezes and is “terminated unexpectedly”.
Therefore I currently am not able to use the program or install an update. Any ideas?
The administrator has disabled public write access.

Program terminates unexpectedlyhttps://www.microm​at.com/components/com_kunena/t​emplate/micromat/imag 27 May 2014 17:44 #5494

The forums are moderated. New postings do not appear until they are approved by a moderator.

Please repair permissions using Disk Utility, and then reinstall TechTool Pro using the TechTool Pro 7.0.4 installer. If you have registered the program here, you will find the installer in the Available Downloads at the bottom of the My Account page. If repairing permissions and reinstalling using the installer does not work, please send a message to This email address is being protected from spambots. You need JavaScript enabled to view it. , including a link to this thread. Thank you.

Remember that the TechTool Pro installer installs the program on the active boot volume.
MicroMat Inc
Makers of TechTool
The administrator has disabled public write access.
Time to create page: 0.277 seconds