Welcome, Guest
Username: Password: Remember me

Search Micromat Forum

Keyword

TOPIC: SENSOR Tests Failed in Techtool 10

SENSOR Tests Failed in Techtool 10 10 May 2019 07:43 #11061

Hi, I've recently run a Full scan of my mac using techtools, and found the only problem being that the Voltage of the CPU 0 Core is at a value of -1.83V, putting it in a failed status. What do I have to do to fix this?
Any help would be greatly appreciated, as I've tried searching online about this but I've come up with nothing.
The administrator has disabled public write access.

SENSOR Tests Failed in Techtool 10 10 May 2019 10:08 #11066

The forums are moderated. New postings do not appear until they are approved by a moderator. I have deleted your two duplicates.

Try to find out what the correct voltage for your model should be. If you send a description of the model to This email address is being protected from spambots. You need JavaScript enabled to view it. , they might be able to give you some advice.
MicroMat Inc
Makers of TechTool
The administrator has disabled public write access.
Time to create page: 0.352 seconds